Machine Specification
The machine is offered complete with the following standard and additional features / equipment.
Standard equipment included:
Traub TX8H 32 bit CNC control system
11Kw A.C. drive motor for main spindle
Main Spindle with spindle nose to DIN 55026-A6 and 65mm bar capacity and infinitely variable spindle speed to Maximum 4000 RPM
Compound Slide with two A.C. servo drives with digital feed back. X and Z axis slide-ways with linear motion bearing guides.
12 Station turret with tool registers for parallel shank to DIN 69880-30 x 55 (30 VDI)
Direction logic
Tailstock on separate guide-way manual pre-positioned with programmable hydraulic Z-axis movement with Hydraulic quill and live centre (319 948)
Hydraulic operated hollow chucking cylinder
Swarf conveyor with 950mm discharge height
Coolant unit with 5 bar pressure and settlement tank, coolant supply through turret.
Hydraulic system
Pivoting control operating panel with colour display screen
Sliding cover over working area incorporating a viewing panel made of laminated safety glass, with safety locking device
Machine light
Traub ‘ATC’ optical tool position measuring device
The machine complies with the valid regulations for prevention of accidents and is CE approved
Electrical equipment, as per VDE/EN 60204 standards, wired to suit a 400 volt, 3 phase 50 cycle A.C. supply 24 volt control voltage.
Interface for data transmission to peripheral equipment via V24 (25-Polar/RS232)
Integral floppy disc drive for 3 ½” discs
Attachments / Options included
Numerically controlled rotating and positioning attachment for main spindle (C-Axis)
Drive for rotating tools by 4Kw servo motor (Infinitely variable programming speeds to maximum 4000 RPM)
Y axis for off centre milling operations +/- 35mm travel
Rohm KFD HS 3 Jaw power chuck
Traub ‘Polyform’ Software for simplified programming of complex milled profiles
12 Static tool holders for turret.
Set of documentation, comprising:
User manual
Programming Manual
Tool holder catalogue
Spare parts manual
Circuit diagram
Parameter disc
Set of standard tooling and accessories.
Machine transportation and commissioning at your works can be arranged
On site setter / operator training available
No warranty offered commencing installation.
The Traub TNA300
 |  |  |
|---|---|---|
 |  |  |
 |
Our Refurbishment Program Revealed
You can see the in depth refurbishment we carry out here at Simon CNC Services. We pride ourselves in our rebuild program giving full attention to detail, no part of the machine gets overlooked bringing a used machine tool a new lease of life and many more years of care free production.
More on the TNA300
The machine is located in our overseas facility. The machine has had a thorough check over and all geometries calibrated. The Machine can be fully dismantled down to the machine bed and rebuilt from ‘scratch’ should you choose our full refurbishment program. Any item of equipment that cannot be refurbished would be replaced.
All Linear guide rails, ball screws, bearings and basic wiring kit are options for replacement. All guards inner / outer have been reconditioned or replaced, all framework and exterior guards could be professionally powder coated.
The machines look new when they hit your shop floor should you proceed with our refurbishment options!
Get In Touch
Simon CNC Services is committed to exceeding your needs. Questions, comments or special requests? We’d love to hear from you, so don’t hesitate to reach out today.
Simon CNC Services Limited,
Unit 1, Old Brick Works Lane,
Chesterfield, S41 7JD
+44 (0)1246 224 111
